產品介紹
Hardware Installation
Please follow below steps to setup MiraScreen cable/adapter:
- Connect MiraScreen to your TV (Monitor or Projector)
- Connect your iOS device and MiraScreen with a Lightning cable
- If the HDMI source is set correctly, you should see the MiraScreen setup screen on TV
For iOS (iPhone/iPad) Device
- After hardware installation properly, your iOS will show up Trust This Computer message, please click on Trust and then enter your passcode to unlock MiraScreen connection.
- Wait for a few seconds and then the screen of your iOS device will be shown on TV.
- Note: Support iOS 10 and above.
- Note: Some iOS devices may popup This accessory may not be supported. This is a normal notification, please feel at ease using it.
Firmware OTA Upgrade using iOS device
- Insert a paper clip into the hole on the MiraScreen dongle, and push the key inside the hole to enable Setup mode
- Enable Personal Hotspot of your iOS device
- Note: Cellular (3G/4G) data is needed at your iOS device
- Download EZCast App, launch it. Click the Wire button on top to establish a connection, and then click the Menu Button on left.
- Click the Firmware OTA button.
- Note: Please DO NOT power off during upgrade.
Setup using an iOS device
- Insert a paper clip into the hole on the MiraScreen, and push the key inside the hole to enable Setup mode
- Follow below steps to turn on the Setup control keypad
產品規格
- 長:1.7M 1080P
- 鋁合金材質 網織線身更強韌防熱